Trade math calculators for plumbing apprentices
Offsets, fall, tank volume and pressure from head. The four calculations that show up at every level, with the formula beside each one.
Offsets
When a pipe has to jog over to miss something, the diagonal piece is the travel. Travel is the offset times a constant for the fitting: 1.414 for 45s, 2.613 for 22½s and 1.155 for 60s.
Use any unit: the answer comes out in the same one. This is centre to centre. Take off the fitting allowances to get your cut length.
Fall on a run
Fall is the length of the run times the grade. At 1/4 inch per foot, a 20 foot run drops 5 inches.
Your code sets the minimum slope for each pipe size. This only does the arithmetic.
Tank volume
A round tank holds the area of the circle times the height. In inches, divide cubic inches by 231 for US gallons.
Canadian water heaters are often labelled in US gallons and litres. Check which gallon a question means: an imperial gallon is about 20 per cent bigger.
Head and pressure
Water standing in a pipe pushes down with 0.433 psi for every foot of height, or about 9.81 kPa for every metre. Going the other way, 1 psi lifts water 2.31 feet.
This is static pressure from height alone. It ignores friction loss in a flowing system.
Do it by hand first
A calculator will not be thinking for you in the exam room. Work each problem on paper, then check it here. If your answer is off, find the step where it went wrong before you move on.
Five minutes a day adds up
Callback is a five-minute daily shift of plumbing questions. Miss one and it comes back until you get it right.